Yamaha MBK XMAX 2014 Service Manual page 68

Item
Immobilizer screw
Battery terminal bolt
Starter relay bracket bolt
Starter relay terminal nut
Horn bolt
Hydraulic unit assembly bolt (for
YP125RA)
Brake hose union bolt (hydraulic
unit) (for YP125RA)
Brake hose (hydraulic unit to front
brake caliper) holder screw (for
YP125RA)
TIP
Ring nut
1. Tighten the lower ring nut 38 Nm (3.8 m·kgf, 27 ft·lbf) with a torque wrench and the steering nut
wrench, and then loosen the nut 1/4 turn.
2. Tighten the lower ring nut 22 Nm (2.2 m·kgf, 16 ft·lbf) with a torque wrench and the steering nut
wrench.
3. Install the rubber washer and the center ring nut.
4. Finger tighten the center ring nut, align the slots of both ring nuts, and then install the lock washer.
5. Hold the lower and center ring nuts, and then tighten the upper ring nut 75 Nm (7.5 m·kgf, 54 ft·lbf)
with a torque wrench and the steering nut wrench.
TIP
Swingarm mounting bolt
1. Temporarily install the rear wheel axle nut "1".
2. Temporarily install the swingarm mounting bolt (upper side) "2", then the swingarm mounting bolt
(lower side) "3".
3. Tighten the rear wheel axle nut to 135 Nm (13.5 m·kgf, 98 ft·lbf).
4. Tighten the swingarm mounting bolt (upper side), then the swingarm mounting bolt (lower side) to
28 Nm (2.8 m·kgf, 20 ft·lbf).
Swingarm tightening sequence:
Thread
Q'ty
size
M5 2 4.0 Nm (0.40 m·kgf, 2.9 ft·lbf)
M5 2 7 Nm (0.7 m·kgf, 5.1 ft·lbf)
M6 1 4.0 Nm (0.40 m·kgf, 2.9 ft·lbf)
M6 2 4.0 Nm (0.40 m·kgf, 2.9 ft·lbf)
M6 1 10 Nm (1.0 m·kgf, 7.2 ft·lbf)
M6 3 7 Nm (0.7 m·kgf, 5.1 ft·lbf)
M10 4 30 Nm (3.0 m·kgf, 22 ft·lbf)
M6 1 9 Nm (0.9 m·kgf, 6.5 ft·lbf)
1
2-21
TIGHTENING TORQUES
Tightening torque
2
3
Remarks