Changing The Engine Oil - Yamaha MBK XMAX 2014 Service Manual

EAS2DM1029

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• Engine oil filler cap "1"
• Engine oil drain bolt "2"
(along with the gasket)
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter element is also to be replaced,
perform the following procedure.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the oil filter element cover "1" and oil
filter element "2".
b. Install a new O-ring "3".
c. Install the new oil filter element and the oil fil-
ter element cover.
1
2
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
PERIODIC MAINTENANCE
TIP
Be sure to face the "
element cover in the direction shown in the illus-
tration.
▲ ▲▲▲ ▲ ▲▲▲ ▲
6. If the oil strainer is also to be cleaned, per-
form the following procedure.
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Remove the oil strainer cover "1" and oil
strainer "2".
b. Install a new O-ring "3".
▼▼▼
c. Install the oil strainer cover.
▲ ▲▲▲ ▲ ▲▲▲ ▲
7. Install:
• Engine oil drain bolt
(along with the gasket
8. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
3-19
" mark "a" on the oil filter
Oil filter element cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
1
Oil strainer cover
32 Nm (3.2 m·kgf, 23 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
New
Engine oil drain bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
a
1
▲ ▲▲▲ ▲ ▲▲▲
▼ ▼▼▼ ▼ ▼▼▼
2
3
New
1
▲ ▲▲▲ ▲ ▲▲▲
)