Replacing The Air Filter Element - Yamaha MBK XMAX 2014 Service Manual

FI diagnostic tool
90890-03182
YU-03182
5. While pressing the "MODE" button "1", turn
the main switch to "ON".
TIP
• "DIAG" appears on the LCD "2" of the FI diag-
nostic tool.
• "POWER" LED (Green) "3" comes on.
3
FI Diagnostic Tool
DIAG
6. Press the "UP" button to select the CO adjust-
ment mode "CO" or the diagnostic mode "DI-
AG".
7. After selecting "CO", press the "MODE" but-
ton.
8. Check that "C1" appears on the LCD of the FI
diagnostic tool, and then press the "MODE"
button.
9. Start the engine.
ECA37P1015
NOTICE
Perform the adjustment after the battery has
been sufficiently charged.
PERIODIC MAINTENANCE
1
10.Change the CO adjustment volume by press-
ing the "UP" and "DOWN" buttons.
TIP
The CO adjustment volume and engine idling
speed appears on the LCD of the FI diagnostic
tool.
• To decrease the CO adjustment volume, press
the "DOWN" button.
• To increase the CO adjustment volume, press
the "UP" button.
11.Release the "DOWN" and "UP" buttons to ex-
ecute the selection.
12.Set the main switch to "OFF" to cancel the
mode.
2
13.Disconnect:
• FI diagnostic tool
14.Connect:
• Self-diagnosis signal coupler
1
15.Install:
• Battery cover
Refer to "GENERAL CHASSIS" on page 4-1.
EAS2DM1022

REPLACING THE AIR FILTER ELEMENT

TIP
Check hoses are located on the bottom of the air
filter case. If dust or water or both collects in a
hose, remove the clamp from the hose, and then
remove the plug to drain the hose.
1. Remove:
• Air filter case cover "1"
• Air filter element
3-8
FI Diagnostic Tool
1 5 5 0 r p m
C1 : -10
1