Yamaha MBK XMAX 2014 Service Manual page 367

Fault code No.
Item
2 Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
3 Wire harness continuity.
4 Installed condition of intake
air temperature sensor.
Check for looseness or
pinching.
5 Defective intake air tempera-
ture sensor.
6 Malfunction in ECU.
22
Intake air temperature sensor: open or short circuit detected.
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
Open or short circuit → Re-
place the wire harness.
Between intake air tempera-
ture sensor coupler and ECU
coupler.
brown/white–brown/white
black/blue–black/blue
Improperly installed sensor
→ Reinstall or replace the
sensor.
Execute the diagnostic
mode. (Code No. D05)
When engine is cold:
Displayed temperature is
close to the ambient temper-
ature.
The displayed temperature is
not close to the ambient tem-
perature. → Check the intake
air temperature sensor.
Replace if defective.
Refer to "CHECKING THE
INTAKE AIR PRESSURE
SENSOR" on page 8-148.
Replace the ECU.
8-54
FUEL INJECTION SYSTEM
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 3.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 4.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 5.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 6.