Installing The Front Wheel (Front Brake Disc) (For Yp125R) - Yamaha MBK XMAX 2014 Service Manual

4. Check:
• Front wheel static balance
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS2DM1004
INSTALLING THE FRONT WHEEL (FRONT
BRAKE DISC) (for YP125R)
1. Install:
• Front brake disc "1"
Front brake disc bolt
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
LOCTITE®
TIP
• Install the brake disc so that the recessed por-
tion of the bolt hole faces away from the hub.
• Tighten the brake disc bolts in stages and in a
crisscross pattern.
1
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
2. Check:
• Front brake disc
Refer to "CHECKING THE FRONT BRAKE
▼▼▼
DISC" on page 4-37.
3. Lubricate:
• Oil seal lips
• Speed sensor oil seal lip
4. Install:
• Collar
• Speed sensor
• Front wheel
TIP
• Make sure that the projection "a" on the wheel
hub do not contact the projections "b" on the
▲▲▲
speed sensor.
• When installing the speed sensor, make sure
that the projection on the wheel hub does not
damage the lip of the speed sensor oil seal.
• Make sure that the slot "c" in the speed sensor
fits over the stopper "d" on the outer tube.
c
d
5. Install:
• Wheel axle
• Wheel axle pinch bolt
4-24
FRONT WHEEL
Recommended lubricant
Lithium-soap-based grease
Wheel axle
59 Nm (5.9 m·kgf, 43 ft·lbf)
Wheel axle pinch bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
a
b