Yamaha MBK XMAX 2014 Service Manual page 169

Rear brake disc bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
LOCTITE®
Rear wheel sensor rotor bolt (for
YP125RA)
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
A
1
B
1
a
2
A. For YP125R
B. For YP125RA
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-53.
3. Install:
• Rear fender
• Air filter case mounting bolts
Air filter case mounting bolt
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
LOCTITE®
TIP
Place the rear fender between the air filter case
and the crankcase, and then install the air filter
case mounting bolts.
4. Install:
• Swingarm
Refer to "REAR SHOCK ABSORBER AS-
SEMBLIES AND SWINGARM" on page
4-85.
5. Measure: (for YP125RA)
TIP
Measure the distance "a" only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
swingarm "2" (edge of the wheel sensor in-
stallation hole "b"))
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
Distance "a" (between the wheel
sensor rotor and swingarm (edge
of the wheel sensor installation
hole))
28.3–28.7 mm (1.114–1.130 in)
4-30
REAR WHEEL
a