E5Cc/E5Ec Setting Levels - Omron E5CC-800 User Manual

3-3-4

E5CC/E5EC Setting Levels

Moving between Setting Levels
The following figure gives an overall image of the setting levels. The setting levels consist of the basic
setting levels (shaded below) and the other setting levels (not shaded).
Manual Control
Level
Used to set the MV
manually.
*1 To use a key procedure to move to Manual Control Level, set the Auto/Manual Select Addition parameter to
ON and set the PF Setting parameter to a-m (Auto/Manual).
*2 The No. 1 display will flash when the keys are pressed for 1 s or longer.
Digital Temperature Controllers (Simple Type) User's Manual (H211)
Only when Manual Mode was
used just before power OFF
Power ON
O Key for at least 1 s
Level changes
or S Key for at least 1 s
automatically.
Operation Level
Used for SP, alarm
values, and other basic
settings and monitoring.
O Key for at least 3 s
while A-M is
*2
displayed or S Key
*1
for at least 1 s
O Key for
*2
at least 3 s
Initial Setting Level
Used to set the input
type and other basic
settings.
Release protection and then
enter the password (−169)
for the amoV (Move to
Advanced Function Setting
Level) parameter.
Advanced Function
Setting Level
Advanced settings
3 Part Names and Basic Procedures
Protect Level
O + M Keys
for at least 1 s
Used to set protection
for operations.
Press O Key once.
Adjustment Level
Used to change
adjustment parameters
(PID constants, control
hysteresis, etc.).
Press O Key once.
O Key for
at least 1 s
Press O Key once (models with communications only).
Communications
Setting Level
Communications settings
Press O Key once.
O Key for at least 1 s
Press O + M Keys
*2
for at least 3 s.
3
3 - 9