Setting Levels Diagram - Omron E5EC Datasheet

E5EC
Operation

Setting Levels Diagram

This diagram shows all of the setting levels. To move to the advanced function setting level and calibration level, you must enter passwords. Some
parameters are not displayed depending on the protect level setting and the conditions of use.
Control stops when you move from the operation level to the initial setting level.
Only when Manual Mode was
used just before power OFF
Press the
S
Manual Control
Level
Used to set the
MV manually.
O
Key pressed for at least 3 s *2
S
or Key pressed for at least 1 s *1
while A-M is displayed
*1. To use a key procedure to move to Manual Control Level, set the Auto/Manual Select Addition parameter to ON and set the PF Setting parameter to a-m (Auto/
Manual).
*2. The No. 1 display will flash in the middle when the keys are pressed for 1 s or longer.
13
Power ON
O
Key or the
Level changes
Key for at least 1 s.
automatically.
Operation Level
Used for SP, alarm values,
and other basic settings
and monitoring.
O
Press the Key
for at least 3 s.*2
Initial Setting Level
Used to set the input type
and other basic settings.
Release protection and then
enter the password (−169)
for the amoV (Move to Advanced
Setting Level) parameter.
Advanced Function
Setting Level
Used to set application
functions.
Enter the password
(1201) for the Move to
Calibration Level parameter.
Calibration Level
Used to calibrate
the E5EC.
Protect Level
O M
Press the and
Keys for at least 1 s.
Used to set protection
for operations.
O
Key once.
Adjustment Level
Used to change adjustment
parameters (PID constants,
adjustment sensitivity, etc.).
O
Key once.
O
Press the Key
for at least 1 s.
O
Press Key once
(models with communications only).
Communications
Setting Level
Used to set communications.
O
Key once.
O
Press the Key for at least 1 s.
O M
Press the and Keys
for at least 3 s.*2