Speed Rate Adjustment; Run Idle; Sbk Function - Adtech 4 Series Maintenance Manual

⑵ press [File]
⑶ Select [data traveler(u)]and press [EOB] to enter;
⑷ Move cursor to select a file in the disk;
⑸ Press [EOB] to load the file into work area (system buffer);
⑹ Press [Auto];
⑺ Press the [Start] to run the program, and the indicator is on.

Caution
The system won't record the USD disk path. If power off during DNC processing, the program info will be lost after power
on ,so if you want to continue,you should do above steps again.

5.4 Speed rate adjustment

Feeding rate
at auto mode, press ―↑‖, ―↓‖key in [Position] interface to adjust the feeding rate; Press the key
once to increase or decrease by 10% (10%-150%).
Jog rate
at Jog mode, press ―↑‖, ―↓‖key in [Position] interface to adjust the Jog rate; Press the key to
increase or decrease by 10% (10%-150%).
Spindle speed
at auto or Jog mode, press the ―→‖,―←‖key to adjust the spindle speed by 100r/min. The maximum
speed is set by the spindle parameters in the system and the minimum speed is 16r/min. If you press and
hold the key for three seconds, the value will be increased or decreased quickly.

5.5 Run idle

(Reserved)

5.6 SBK function

at auto mode, press [SBK] to start the SBK function. Current program stop; press [Start] again and
next line stops after executing. The SBK mode can checking the program line by line.

Caution:
① In G28-G30, single line also can be stopped at the midpoint;
② The stop points of single line in fixed circle are ①, ②, ⑥ in the figure below; when the single line of ①, ② stops, the
feeding pauses and the pause indicator is on.
ADTECH 4 series CNC System (maintainance Manual)
21