Adtech 4 Series Maintenance Manual page 73

027 Arc Acc.for Speed
Range
Unit
Authority
Default
Effective time
Note
028 PretreatmentCode Set
Range
Unit
Authority
Default
Effective time
Note
Inp AccSpeed Mode
029
030 'S'Speed Acceleration
Range
Unit
Authority
Default
Effective time
Note
031 HOME Check for alarm
032 HOME Check Enable
Range
Unit
Authority
Default
Effective time
Note
ADTECH 4 series CNC System (maintainance Manual)
:
: Coefficient
: Operation admin or higher
: 50, 100
: Instant
Used to restrict the arc processing speed automatically. This parameter is
:
valid in pretreatment mode.
The bigger the radius coefficient is, the lower the arc speed is.
The bigger the acceleration coefficient is, the higher the arc speed is.
: 100~3000
: Instruction line
: Operation admin or higher
: 500
: Instant
Set the pre-reading instruction lines; if the pretreatment processing
:
pauses and pre-reads, please increase this value to pre-read more
instructions.
:
:
: Operation admin or higher
:
: Instant
Inp AccSpeed Mode: it for setting the interpolation acceleration/
:
deceleration, 0 is linear acceleration and deceleration ; 1 is S curve
acceleration/deceleration
'S'Speed Acceleration: Used to set the performance of S curve
acceleration/deceleration
: 0~1
:
: Operation admin or higher
: 0, 1
: Instant
: HOME Check for alarm :if there is alarm in controller ,and after the
alarm removed ,the controller need go home point or not before working.
0 : disable ,no need go home point before working
1: enable ,need go home before working.
HOME Check Enable :after power on ,the controller whether go home
point or not
69