Table of Contents
Advertisement
Echoflex Installation Guide
Power Load Controller
Installation
Ensure that the junction box is clean and free of obstructions and that all
wiring is installed correctly. Review these instructions completely before
installing the controller.
Note:
requirements when installing and powering the controller.
Install the Controller
The controller can be mounted directly to the exterior of the junction box
or panel either at the electrical load or before the load in the circuit.
1. Locate the circuit breaker panel and terminate power to the circuit.
2. Remove the cover plate and other hardware from the junction box to
access the wiring.
3. Mount the controller.
4. Refer to the
power, neutral, and load wires. Use wire nuts on all connections and
individually cap any bare wires, except the orange antenna wire.
5. Replace the electrical box cover plate and restore power to the circuit.
Note:
The USB port is for factory use only. Do not attach cables or
accessories to this port.
Wiring Diagram
White: Neutral
Black: Line (hot),
120-277 V or 240-347 V
@ 50/60 Hz 500 mW max
Antenna (orange)
Do not cut or cap
Power
LED
Power Load Controller
Follow applicable NEC and local electrical code
Wiring Diagram below
Red: Load, switched hot
ELEDR or ELEDRH
Power Load Controller
Clear
Learn
Learn
Button
Button
LED
to connect the controller to line
Neutral to others
Load
Max. Switching Load
(ELEDR) 20 A @ 120-277 V, Electronic Ballast or LED Driver
(ELEDRH) 20 A @ 240-277 V, Electronic Ballast or LED Driver
(ELEDRH) 16 A @ 347 V, Electronic Ballast or LED Driver
Max. Impulse Voltage: 4000 V
Internal Relay: Type 1.C
Motor Load Rating: 1.5 HP @ 120 V and 3.0 HP @ 277 V
Page 3 of 8
Red: to other loads
Red: to other loads
Max. Load:
(ELEDR) 20 A @ 120-277 V,
Electronic Ballast or LED Driver
(ELEDRH) 20 A @ 240-277 V,
Electronic Ballast or LED Driver
(ELEDH) 16 A @ 347 V,
Electronic Ballast or LED Driver
Echoflex
Advertisement
Table of Contents
