Table of Contents
Advertisement
Echoflex Installation Guide
ELED2 Controller
Installation
Ensure that the junction box is clean and free of obstructions and that all
wiring is installed correctly. Review these instructions completely before
installing the controller.
Note:
requirements when installing and powering the controller.
Install the Controller
The controller can be mounted directly to the exterior of the junction box
or panel either at the electrical load or before the load in the circuit.
1. Locate the circuit breaker panel and terminate power to the circuit.
2. Remove the cover plate and other hardware from the junction box
to access the wiring.
3. Mount the controller.
4. Refer to the
controller to line power, neutral, and load wires. Use wire nuts on
all connections and individually cap any bare wires, except the
orange antenna wire.
5. Replace the electrical box cover plate and restore power to the
circuit.
Note:
The USB port is for factory use only. Do not attach cables or
accessories to this port.
ELED2 Controller
Follow applicable NEC and local electrical code
Wiring Diagrams on the next page
Page 3 of 12
to connect the
Echoflex
Advertisement
Table of Contents
