Installation; Removal From Din Rail - ETC response SnapBack RSN-SB-DIN Setup Manual

ETC Setup Guide
Response SnapBack
Preset Status Query
Command E$pst query: dev_num [term]
Example: E$pst query: 5
• This command generates a response that identifies the active preset on device 5 and sends it
to the IP/port that sent the query.
• If preset 8 is active, the response message is E>pst act 5, 8.
• If no preset is active, the response is E>pst act 5, 0.
Help
Command E$help [term]
Example: E$help \n
This command generates a response that provides information on these commands and sends it to
the IP/port that sent the query.

Installation

Note:
Mount to DIN Rail
1. Ensure the section of DIN rail to be used is mounted securely
according to the manufacturer's requirements.
2. Hook the top of the device over the upper DIN rail edge as
shown.
3. Depress until the bottom clip on the device seats completely
onto the DIN rail.

Removal from DIN Rail

To remove the device from the DIN rail, insert a small screwdriver into
the retaining clips on the top of the device and push the screwdriver
down to open the clips. Insert the screwdriver into the bottom
retaining clips and push up to fully release the device from the DIN
rail.
Response SnapBack
Installation must follow all national and local codes for electrical equipment.
Page 4 of 8
3
2
ETC