Table of Contents
Advertisement
Echoflex Installation Guide
Power Load Controller
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING:
high voltage and should only be installed by a qualified
installer or electrician. Follow all local codes for
installation. Before terminating the AC power wiring verify
that the main breaker is in the off position and follow the
proper lockout/tag out procedures required by NFPA
Standard 70E.
AVERTISSEMENT :
appareil utilise une haute tension et ne doit être installé
que par un installateur qualifié ou un électricien. Suivez
tous les codes locaux pour l'installation. Avant de raccorder
le câblage du courant alternatif, vérifiez que le disjoncteur
principal est en position d'arrêt et suivez les procédures de
vérouillage/étiquetage prescrites par la norme NFPA 70E.
WARNING:
electrical junction box or wireway.
AVERTISSEMENT :
Doit être installé sur une boîte de raccordement électrique
ou un chemin de câbles.
This product is suitable for use in dry locations where the ambient
•
temperature is -5°C to 50°C (23°F to 122°F).
Do not use outdoors.
•
Do not mount near gas or electric heaters.
•
Equipment should be mounted in locations and at heights where it is
•
not subject to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the
•
manufacturer may cause an unsafe condition.
Do not use this equipment for other than its intended use.
•
Servicing should be performed by qualified service personnel.
•
Pollution Degree: 2.
•
SAVE THESE INSTRUCTIONS
Power Load Controller
RISK OF ELECTRIC SHOCK! This device utilizes
RISQUE DE DÉCHARGE ÉLECTRIQUE! Cet
For indoor use only! Must install to an
Uniquement pour usage d'intérieur!
Page 2 of 8
Echoflex
Advertisement
Table of Contents
