Compaq 3200 Reference Manual page 35

3-4 Updating the Firmware
To run System ROMPaq:
1. Place the System ROMPaq diskette in the server diskette drive.
2. Boot the server by turning on the power.
3. Press Enter at the Welcome screen.
4. At the Select A Device screen, select the server from the list of the
programmable devices. This may be the only item in the list. Press Enter.
5. At the Select An Image screen you will see:
Press Enter.
6. Review the information on the Caution screen:
Press Enter to reprogram the system ROM or Esc to discontinue
reprogramming and return to the Select An Image screen.
7. "Reprogramming Firmware" indicates that the system ROM is being
reprogrammed. DO NOT INTERRUPT.
IMPORTANT: Do not interrupt this cycle. Interrupting the ROM
reprogramming will leave the firmware in an unknown state. You may not be
able to boot the server if this happens. You will be notified when
reprogramming is complete.
8. When ROMPaq finishes reprogramming the system ROM, press Esc to
exit the System ROMPaq utility.
9. Remove the System ROMPaq diskette and reboot the server by cycling
the power (cold boot).
If you have not installed your new Smart Array 3200 Controller, install it now.
Writer: Rickard Project: Compaq Smart Array 3200 Controller Reference Guide Comments: 340862-002
Device to reprogram:
Current ROM revision:
Select Firmware Images:
Device to reprogram:
Current ROM revision:
Selected ROM revision:
File Name: D-CH03.DOC Last Saved On: 12/7/98 1:19 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
your server
date of existing ROM version
date of latest ROM version
your server
date of existing ROM version
date of ROM version to be installed