Epson Equity IIe User Manual page 56

To select
2.
menu such as the following:
Drive 1:
Number of cylinders
Number of heads
Number of sectors
Precomp. cylinder
Landing zone
Total capacity (MB)
The submenu lists the settings you can change for each
drive: the number of cylinders (tracks), the number of read/
write heads, the number of sectors, the precompensation
cylinder, the landing zone (the cylinder on which you want
to park the heads when moving the computer), and the
total storage capacity in megabytes.
3. If you want to change the settings for Drive 1 (which is
drive C on most computers), press
Drive 2, press
4. Enter.
Press
5. If you want to change the drive type and the configuration
of the hard disk you are installing matches one of the drive
types listed in Appendix E, go to step 6.
2-20 Running the Setup Program
59
Type
980
5
17
None
979
40.7
1 :. If you want to change the settings for
and then + to highlight
Enter
You see this submenu:
press
Enter. You
Drive 2:
None
to highlight
Enter
see a