Epson Equity IIe User Manual page 125

2. If you don't have a hard disk, insert your Working 1
(5 '/.+-inch) or Startup (3 '/z-inch) diskette into drive A.
3. If you have a hard disk, type
drive C. If you do not have a hard disk, type
to log onto drive A.
Enter
4. At the MS-DOS command prompt, type the following and
press
Enter:
DISKCOPY A: A:
MS-DOS displays these messages:
Insert SOURCE diskette in drive A:
Press any key to continue . . .
5. Remove the diskette in drive A, if necessary, and insert the
diskette you want to copy from (the source diskette) into
the drive. Then press any key. DISKCOPY starts to copy
the contents of the diskette to the computer's memory.
When the computer's memory is full, the screen displays
these messages:
Insert TARGET diskette in drive A:
Press any key to continue . . .
6. Remove the source diskette from drive A and insert the
diskette you want to copy to (the target diskette). Then
press any key. If the target diskette is not formatted,
DISKCOPY formats it before copying data to it.
7. After DISKCOPY copies the data from memory to the
target diskette, the screen prompts you to insert the source
diskette again to copy the remaining data to the computer's
memory (if necessary). Insert the source diskette into
drive A and press any key.
: and press
Using MS-DOS with Your Equity IIe
to log onto
Enter
: and press
4-35