Front Perc Module; Removing The Front Mounting Front Perc Module; Installing The Front Mounting Front Perc Module - Dell PowerEdge R6625 Installation And Service Manual

Front PERC module

Removing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, Remove the air
5. Disconnect all the cables, observe the cable routing.
Steps
1. Disconnect the cable from the front PERC module.
2. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
3. Pull the front PERC module to disengage from the connector on the drive backplane.
4. Tilt and lift the front PERC module out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 82. Removing the front mounting front PERC module
Next steps
● Replace the front mounting front PERC module

Installing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
Safety instructions.
Before working inside your
cover.
shroud.
Safety instructions.
Before working inside your
cover.
system.
system.
Installing and removing system components 105