Table of Contents
Advertisement
Figure 47. Installing the right control panel
Next steps
1.
Install the drive backplane
2. If removed,
Install the air
3. Follow the procedure listed in
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
Remove the air
Steps
1. Disconnect the control panel cable from the connector on the system board.
2. Press and pull the latch to slide the cable out of the clip.
NOTE:
Observe the routing of the cable as you remove it from the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel to the system.
4. Hold the left control panel cable, and slide the left control panel out of the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
cover.
shroud.
After working inside your
Safety
instructions.
Before working inside your
shroud.
system.
system.
Installing and removing system components
81
Advertisement
Table of Contents
