Table of Contents
Advertisement
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
2. Slide the BOSS-N1 card carrier out.
Figure 140. Removing the BOSS-N1 card carrier
3. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card
carrier.
4. Slide the M.2 SSD out from the BOSS-N1 card carrier.
Figure 141. Removing the M.2 SSD
5. Disconnect the BOSS-N1 power and signal cable from the system board.
6. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module on Riser 1.
7. Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Installing and removing system components
159
Advertisement
Table of Contents
