Table of Contents
Advertisement
Installing the system requires information about the following topics:
● Placemat
● Initial system setup and configuration
Topics:
•
Placemat
•
Rails and cable management information
•
Initial system setup and configuration
Placemat
The Service Information Label and Getting Started Guide documents provide helpful diagrams on setting up the system.
●
Service Information Label
● Getting Started Guide at
Rails and cable management information
The rail offerings for the PowerEdge R6625 consist of two general types: sliding and static. The cable management offerings
consist of an optional cable management arm (CMA) and an optional strain relief bar (SRB). See the Dell Enterprise Systems
Rail Sizing and Rack Compatibility Matrix available at
Docs_Documents/en/rail-rack-matrix.pdf
● Specific details about rail types.
● Rail adjustability ranges for various rack mounting flange types
● Rail depth with and without cable management accessories
● Rack types that are supported for various rack mounting flange types
Key factors governing proper rail selection include the following:
● Spacing between the front and rear mounting flanges of the rack
● Type and location of any equipment that is mounted in the back of the rack such as power distribution units (PDUs)
● Overall depth of the rack
Sliding rails features summary
The sliding rails allow the system to be fully extended out of the rack for service. There are two types of sliding rails available,
ReadyRails II sliding rails and Stab-in/Drop-in sliding rails. The sliding rails are available with or without the optional cable
management arm (CMA) or strain relief bar (SRB).
B6 ReadyRails sliding rails for 4-post racks
● Supports drop-in installation of the chassis to the rails.
● Support for tool-less installation in 19" EIA-310-E compliant square or un-threaded round hole 4-post racks including all
generations of the Dell racks.
● Support for tooled installation in 19" EIA-310-E compliant threaded hole 4-post racks.
● Support full extension of the system out of the rack to allow serviceability of key internal components.
● Support for optional strain relief bar (SRB).
● Support for optional cable management arm (CMA).
NOTE:
For situations where CMA support is not required, the outer CMA mounting brackets can be uninstalled from
the sliding rails. This reduces the overall length of the rails and eliminates the potential interferences with rear mounted
PDUs or the rear rack door.
188
Installation
https://www.dell.com/poweredgemanuals
https://i.dell.com/sites/csdocuments/Business_solutions_engineering-
for information regarding:
9
Installation
Advertisement
Table of Contents
