Dell PowerEdge R6625 Installation And Service Manual page 54

Table of Contents

Advertisement

Table 44. Processor Settings details (continued)
Option
Configurable TDP
x2APIC Mode
Number of CCDs per Processor
Number of Cores per CCD
Processor Core Speed
Processor Bus Speed
Processor n
Table 45. Processor n details
Option
Family-Model-Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Microcode
SATA Settings
To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
SATA Settings.
Table 46. SATA Settings details
Option
Embedded SATA
54
Pre-operating system management applications
Description
Allows the reconfiguration of the processor Thermal Design
Power (TDP) levels based on the power and thermal delivery
capabilities of the system. TDP refers to the maximum amount
of power the cooling system is required to dissipate. This
option is set to Maximum by default.
Enables or disables x2APIC mode. This option is set to
Enabled by default.
Controls the number of enabled CCDs in each processor. This
option is set to All by default.
Specifies the number of cores per CCD. This option is set to
All by default.
Specifies the maximum core frequency of the processor.
Displays the bus speed of the processor(s).
The following settings are displayed for each processor that is
installed in the
system:
Description
Specifies the family, model, and stepping of the processor as
defined by AMD.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
Specifies the processor microcode version.
Description
Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes.
This option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you
should set the field to Non-RAID mode.
NOTE:
This option is only available on certain SKUs of the
processors, and the number of alternative levels varies as
well.
NOTE:
For two CPU 64 cores configuration, x2APIC
mode is not switchable if 256 threads are enabled (BIOS
settings: All CCD, cores, and logical processors enabled).
NOTE:
Depending on the number of CPUs, there might be
up to n processors listed.

Advertisement

Table of Contents
loading

This manual is also suitable for:

E95s

Table of Contents