Table of Contents
Advertisement
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the BOSS card connector.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 148. Removing the M.2 SSD module
Next steps
1.
Replace the M.2 SSD
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS card. Removing BOSS card is similar to
Steps
1. Align the M.2 SSD module at an angle with the BOSS card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
164
Installing and removing system components
module.
Safety
Before working inside your
instructions.
system.
removing expansion card from the expansion card
riser.
Advertisement
Table of Contents
