Installing A Drive In A Horizontal Bay - Epson Endeavor L User Manual

If you removed one hard disk drive and are leaving another
one in the computer, you need to set the jumpers on the
remaining drive to indicate that you now have only one hard
disk drive. For the correct settings, see the documentation that
came with the drive.

Installing a Drive in a Horizontal Bay

This section describes how to install a drive in a horizontal bay.
Although the illustrations show a drive being installed in the
lower bay, you can use these instructions to install a drive in
the upper bay as well. You'll find steps for the following
procedures:
0 Attaching the mounting frames to a hard disk drive (if
necessary)
0 Installing the drive
0 Connecting the cables.
If you are installing your computer's first hard disk drive, it is
best to use the vertical drive bay as described on page 5-2.
N o t e
Before you install a hard disk drive, be sure to check the
jumpers on the drive. For instructions, see page 5-2.
5-14 Installing and Removing Drives