Installation Help; Unpairing/Re-Associating The Receiver With The Transmitter - DELTA DORE Tybox 5300 Quick Start Manual

7. Installation help

7.1 Unpairing/re-associating the receiver with the transmitter

If there's a fault, you may need to unpair a product and/or re-associate a new one.
Wireless resetting of the transmitter
1
mode mode
>3s
❶ On the Tybox, briefly press a
button to wake up the display,
then press and hold both the
mode and + buttons for 3 seconds.
Removing associations from the receiver
The deletion of wireless associations with the receiver is carried out by holding down the button.
The LED will cycle through the various states.
A
3s
: The LED flashes red. The receiver is in pending association mode.
: The red LED is on and steady. The receiver is in "Heating configuration selection" mode.
: The red LED flashes rapidly. The receiver is waiting to delete the association with a door/window magnetic
contact (check on the device you want to unpair).
: The red LED turns off. All associations with the receiver are now removed.
: If you hold down the button for 30 seconds, the LED flashes 3 times.
The receiver is fully reset (back to factory settings).
Associating the receiver(s) with the transmitter
1
>3s
... ... ...
The green LED light on the receiver
flashes rapidly, indicating that it has
not been associated (if you have
proceeded with resetting it).
❶ To associate it, press the receiver
button for 3 seconds, until the red
LED flashes. Release.
2
>3s
❷ The screen displays rF--
depending on the number of
associated receivers
(e.g.: rF01 for a single receiver, rF02
for 2 receivers etc...).
Press - for 3 seconds to confirm
the reset.
The screen displays rF00.
> 30s
B C
6s 10s
mode
mode
2
>3s
❷ On the Tybox, briefly press a
button to wake up the display, then
press and hold both the mode and +
buttons for 3 seconds.
The screen will display rF00. Release.
❸ Press briefly on +. The screen
flashes until rF is displayed
depending on the number of
associated receivers (eg. rF01 for a
single receiver, rF02 for 2 receivers
etc.).
3
mode
❸ Briefly press the mode and +
If the receiver is supplied with power and is
within the wireless range of the transmitter
at the time of the reset, the transmitter will
also be deleted on the receiver.
D
20s
3
❹ Check that the LED of the
receiver(s) is no longer flashing.
To exit the mode, briefly press the
mode and + buttons simultaneously.
buttons at the same time.
The screen displays dF 0
(transmitter not yet associated).
E
30s
OFF
mode
4
7