Installation Assistance; Unpairing/Re-Associating The Receiver With The Transmitter - DELTA DORE Tybox 137+ Installation And User Manual

11. Installation Assistance

11.1 Unpairing/re-associating the receiver with the transmitter

If there's a breakdown, you may need to unpair a product and/or re-associate a new one.
Unpairing the transmitter from the receiver
>5s
2
1
❶ Turn the dial on the transmitter
to , then press the i button for 5
seconds (❷).
Re-associating the receiver to the transmitter
... ... ...
1
> 3s
... ... ...
❶ Press the receiver button for 3
seconds until the red LED flashes.
Release.
❷ Turn the dial on the transmitter
to , then press the i button for 5
seconds (❸).
>5s
3
❸ Press the R button for 5 seconds.
❹ Then press the OK button to
confirm the reset.
If the green light is flashing (in flashes), make sure it is flashing in a
... ...
sequence of single flashes. If it is not in the single flash sequence, your
receiver will not be able to associate with the transmitter
Choose the number of flashes by successive presses on the button:
1 flash -> Press -> 2 flashes -> Press -> 3 flashes -> Press ->
.. .. ..... .. ..
3
>5s
2
❹ Briefly press R.
The display shows rAd 0.
❺ Briefly press
❻ The "0" flashes then displays "1".
The receiver LED stops flashing.
4
❺ Press R to verify that rAd = 0.
❻ To exit the mode, turn the dial.
5
4
❼ To exit the mode, turn the dial.
i
.
5
6
1 flash...
6
7
OFF
EXIT
EXIT
11