Table of Contents
Advertisement
Menu CF06 Activation/Deactivation of the anti-seizing function
Anti-seize can be used outside heating periods to regularly start up the circulator during off periods (5 minutes/
week).
Menu CF07 Selection of the heating configuration
The heating configuration is dependent on the generator (e.g. reversible heat pump).
Menu CF08 Control time base
The control quality depends on parameters like the building's insulation, the number of radiators or the flooring
type.
The "Tips" column in the following table will help you select the setting that is appropriate for your installation.
Default setting: 15 minutes.
Choice of
control type
15 minutes
(2)
30 minutes
(2)
45 minutes
(2)
60 minutes
(2)
On-Off
(3)
(1) The control is fitted with anti-short cycle protection to suppress start or stop requests when they are too short. The anti-short cycle
duration is 10% of the time base selected (e.g.: if the time base is set to 30 minutes, the anti-short cycle will be 3 minutes, i.e. the
thermostat will not accept any start or stop requests that are under 3 minutes).
(2) PID control time base:
(3) On-off control: not compatible with the RF6420 and RF6450 receivers.
Menu 2-11 Hysteresis setting (if 2-08 = tor)
Default setting: 0.4°C.
Exiting the Configuration Menu
Press mode for 5 seconds.
Anti-seize off
Anti-seize on
Heating
Air conditioning
Heating/Cooling
Transmitter
Generator
type
Boiler/Heat pump
Heater
Aeraulic
damper
Radiator
Boiler/Heat pump
Underfloor
heating
Underfloor
Boiler/Heat pump
heating
Underfloor
Heat pump
heating
Radiator
Underfloor
Heat pump
heating
Oven range
heating
Aeraulic
Heat pump
damper
Adjusts from 0.2°C to 2°C,
in increments of 0.1°C.
Default setting: Anti-seize disabled
Default setting: heating / air conditioning
type
Increase the time base to extend generator run
times and thus reduce the frequency of start up.
(1)
Retain this setting if the installation is equipped
HP
with a general RF6450 receiver (optional)
Increase the time base to extend generator run
times and thus reduce the frequency of start up.
(1)
(1)
Reduce the time base if you notice big differences
(1)
Only recommended if the PID control isn't
(1)
Recommended hysteresis value: between 0.4 and 1
Hysteresis value: follow the value recommended
Hysterisis value to be adapted following
(1)
Example:
Setpoint 20°C. Hysteresis 0.4°C.
Heating request if T° measured <19.8°C.
Heating shuts down if T° measured> 20.2°C.
Tips
in temperature.
satisfactory.
by the range's manufacturer
installation
5
Advertisement
Table of Contents
