Epson PowerLite 737c User Manual page 60

note
If you want to enter a blank
space, use the space character
that comes before the capital
letter A.
If you want to enter
numbers, use the numeric
keypad while holding down
the button on the
Num
remote control. Press the
button again to exit
Num
numeric keypad mode.
note
The projector keyword
changes each time you turn
the projector off and then on
again, or remove and
reinsert the 802.11g card.
Check the keyword on the
EasyMP Network screen
whenever you start EasyMP,
and enter that keyword on
your computer. You can't
connect using a previous
keyword.
Presenting Through a Wireless Network
60
Make sure
Access point mode
not, use the pointer button on the remote control to highlight
the checkbox next to
to select it.
4. Make sure the projector has a unique name so you can identify it
when connecting to it from your computer.
If you need to rename it, highlight the Projector Name text box
and press . The text box turns yellow to indicate you are in
Enter
input mode. Press the
letters in alphabetical order, or down to select letters in reverse
order; then press the
the next character position. When you're done typing the new
name, press .
Enter
5. To enable your computer to find the projector on the network,
you need to enter an ESSID, which is the SSID name of your
access point or the name of your AirPort network. (The name of
your AirPort network may be different from that of your AirPort
base station; select your base station in the AirPort Admin utility
and click
Configure
Highlight the
ESSID
When you're done, press
case-sensitive (if you enter the name in uppercase on the
projector, you must type it the same way on the computer
connecting to the projector).
6. If you want to create a password for remote access to the
projector, highlight the
press , and enter a password of up to 8 alphanumeric
Enter
characters. When you're done, press
7. If you want to set up a security keyword so that only people who
are in the same room as the projector can access it, turn
on. Then when you want to connect to the projector, it
keyword
displays a randomized four-digit number or "keyword" on the
screen. When prompted by NS Connection, you can enter the
keyword on your computer to connect (see page 77).
is selected, as shown above. If
, then press
Access point mode
pointer button up to select individual
pointer button to the right to move to
to check the name of your network.)
text box, press , and enter a name.
Enter
. Note that the ESSID is
Enter
Password for WEB control
.
Enter
Enter
text box and
Projector