10 Replace the top cover on the chassis (see
a
Hold the cover at an angle and slide it onto the chassis.
b Using a screwdriver, insert and tighten the 4 screws to secure the cover to
the chassis.
11 If the Contivity 1740 is installed in an equipment rack, mount it in the rack.
a
Set the Contivity 1740 on the rack-mount shelf in the rack.
b Insert one of the panhead screws through the bottom hole on each side of
the shelf into the hole in the rack and tighten the screws (see
page
25).
12 Replace the front bezel (see
a
Hold the bezel by its two handles and push it onto the chassis.
b Using the screwdriver, tighten the 2 screws to secure the bezel to the
chassis.
Chapter 4 Installing option cards and DIMMs 67
Figure 21 on page
Figure 25 on page
64).
58).
Figure 4 on
Installing the Contivity 1740