KYMCO CV3 Series Manual page 72

4
Control Functions of Mechanism
learning.
8. The operator will also go the next tire and repeat the
above steps for code-learning settings.
9. If one wishes not to code-learn, press the "O" button
to skip to the next round of code-learning. If code-
learning is not completed within 2 mins, it will exit the
code-learning mode.
10. After the code-learning settings, press the "O" button
to leave exit, or press KEYLESS main switch ON-
OFF to restart.
1. After acquiring the vehicle, inflate the tire till over
20psi and then let the TPMS PC learn the initial value
automatically so that it may operate normally in the
future.
2. Re-do Code Learning after replacing parts.
3. Because the tire pressure detector is mounted on the
nozzle position, keep the tool-inserting position away
from the nozzle when replacing the tire.
4. Make sure the direction is correct when replacing a
part.
5. Tire Pressure values are for reference only.
Caution
6. Slackening of nut during parts installation will cause
air leakage.
7. If the tire pressure cannot be detected, it means the
tire pressure detector battery is running out of the
power. In this case, make a part replacement.
72
3