Protocol
Channel Width
Channel
Auto Channel
Update
Output Power
Client Signal
Strength
Threshold
Maximum number
of clients
Advanced Wi-Fi AP settings can be displayed by clicking the
of the Wi-Fi AP Settings section, which can be found at AP>Settings. Other models will
display a separate section called Wi-Fi AP Advanced Settings, which can be found at
Advanced>Wi-Fi Settings.
https://www.peplink.com
AP Settings (part 2)
This option allows you to specify whether 802.11b and/or 802.11g client
association requests will be accepted. Available options are 802.11ng and
802.11na. By default, 802.11ng is selected.
Available options are 20 MHz, 40 MHz, and Auto (20/40 MHz) . Default is
Auto (20/40 MHz), which allows both widths to be used simultaneously.
This option allows you to select which 802.11 RF channel will be utilized.
Channel 1 (2.412 GHz) is selected by default.
Indicate the time of day at which update automatic channel selection.
This option is for specifying the transmission output power for the Wi-Fi AP.
There are 4 relative power levels available – Max, High, Mid, and Low. The
actual output power will be bound by the regulatory limits of the selected
country.
This setting determines the maximum strength at which the Wi-Fi AP can
broadcast
This setting determines the maximum number of clients that can connect to
this Wi-Fi frequency.
62
on the top right-hand corner
Copyright @ 2019 Pepwave