peplink PEPWAVE MAX BR2 Pro User Manual page 41

Routing Mode
IP Address /
Subnet Mask /
Default Gateway
PPPoE Username /
Password
Confirm PPPoE
Password
Service Name
(Optional)
IP Address
(Optional)
DNS Servers
https://www.peplink.com
PPPoE Settings
NAT allows substituting the real address in a packet with a mapped address
that is routable on the destination network. By clicking the help icon in this
field, you can display the IP Forwarding option, if your network requires it.
This information is obtained from the ISP automatically.
Enter the required information in these fields in order to connect via PPPoE to
the ISP. The parameter values are determined by and can be obtained from
the ISP.
Verify your password by entering it again in this field.
Service name is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
If your ISP provides a PPPoE IP address, enter it here.
Note: Leave this field blank unless it is provided by your ISP.
Each ISP may provide a set of DNS servers for DNS lookups. This setting
specifies the DNS (Domain Name System) servers to be used when a DNS
lookup is routed through this connection. Selecting Obtain DNS server
address automatically results in the DNS servers being assigned by the
WAN DHCP server to be used for outbound DNS lookups over the
connection. (The DNS servers are obtained along with the WAN IP address
assigned from the DHCP server.) When Use the following DNS server
address(es) is selected, you may enter custom DNS server addresses for
this WAN connection into the DNS Server 1 and DNS Server 2 fields.
41 Copyright @ 2019 Pepwave