peplink PEPWAVE MAX BR2 Pro User Manual page 48

Idle Disconnect
Health Check
Method
Timeout
Health Check
Interval
Health Check
Retries
Recovery
Retries
Dynamic DNS
Service
Provider
https://www.peplink.com
state. When Remain connected is chosen, bringing up this WAN connection to active
makes it immediately available for use.
When Internet traffic is not detected within the user-specified timeframe, the modem
will automatically disconnect. Once the traffic is resumed by the LAN host, the
connection will be re-activated.
Health Check Settings
This setting allows you to specify the health check method for the cellular connection.
Available options are Disabled, Ping, DNS Lookup, HTTP, and SmartCheck. The
default method is DNS Lookup. See Section 10.4 for configuration details.
If a health check test cannot be completed within the specified amount of time, the test
will be treated as failed.
This is the time interval between each health check test.
This is the number of consecutive check failures before treating a connection as down.
This is the number of responses required after a health check failure before treating a
connection as up again.
Dynamic DNS Settings
This setting specifies the dynamic DNS service provider to be used for the WAN based
on supported dynamic DNS service providers:
● changeip.com
● dyndns.org
● no-ip.org
48 Copyright @ 2019 Pepwave