Before Starting Engine - Bell B35E 6X6 ADT Operator's Manual

29. Check the Tyres for cuts and damage.
30. Check the tyre pressures (refer to the decal for
pressures).
31. Check the fuel level.
32. Check the Adblue® / DEF Level (SCR trucks
only).
33. Remove any combustible material on and
around high heat areas.
34. Ensure that the windshield, side and rear win-
dows and the rear view mirrors are clean, pro-
vide good visibility and are not damaged.
35. Ensure that the headlights and all exterior lights
and reflectors are clean and undamaged.
36. Ensure that there are no obstructions around
the machine before moving off.
37. Ensure that there are no obstructions in the
cab, especially under and around the pedals
and controls before moving off.
38. Ensure that the seat belt is in proper working or-
der and fasten the seat belt before start-up.

Before Starting Engine

1. Ensure that the Daily or 10 Hourly Service
Checks have been completed. Ad just the oper-
ator's seat for the best operator comfort and
easy access to the machine controls.
2. Ensure the battery isolator switch is turned ON.
3. Fasten the seat belt and adjust the seat belt to
fit firmly across the front of the pelvis.
4. Close the cab door.
5. Sound the horn to warn people in the area that
the engine is about to start and the machine will
be in use.
NOTE
If the automatic horn option is enabled,
the horn will be activated automatically
when the operator presses the engine
start button. The horn will sound twice
before the engine starts.
OPERATING INSTRUCTIONS
Starting Up & Switching off the
Engine
Do not start the machine by shorting across starter termi-
nals. Never start the machine while standing on the ground.
Always start machine from operator's seat. Only start
the engine and operate the machine in well ventilated
areas.
Do not run the engine at high speed (rpm) or heavy loading
until the engine oil, transmission fluid and hydraulic fluid
have warmed up to normal operating temperatures.
DO NOT ignore any Service Due (or over due) messages.
Report to Service Personnel immediately.
1. Check / perform the procedures in Before Start-
ing the Engine (previous instruction).
NOTE
The park brake was applied and the
gear shift will be in the neutral position
when the machine was shut down. The
engine cannot be started unless the
transmission is in Neutral.
2. Press the Ignition On/Engine Start switch (1),
the LED (2) above the switch will flash.
3. Enter your driver access code (Last 4 digits of
the machine PIN number) using the numbers
on the switches on the SSM. e.g. "4503" from
PIN the PIN Number - "B93A336DC07204503"
4. The engine will crank and start automatically. If
the Ignition On/Engine Start switch is pressed
while the ignition LED is flashing and the secur-
ity code has been accepted.
OPERATION