Battery Charge Warning Light - Bell B35E 6X6 ADT Operator's Manual

The Adblue warning light will illuminate when the
level of Adblue in the tank has reached low level or
the quality of the Adblue is inferior. (Refer to the
DEF & LIM Warning Light Trigger & Detection)
Table on the next page.
Main Warning Light
Continued operation of the machine with the main
warning light illuminated will cause serious damage to
the engine or transmission.
The machine must be stopped as soon as it is safe
to do, when this light is on.
A warning buzzer also sounds when the main
warning light flashes if the engine is running.
Engine Fault Warning Light
If a fault to the engine occurs the engine fault
warning light (3) will illuminate.
Stop the machine as soon as it is safe.
Check the fault codes and the required action to
rectify the fault.
OPERATING COMPONENTS

Battery Charge Warning Light

If the battery charge warning light illuminates, the fault
must be rectified or the batteries will be discharged.
The warning light illuminates if the alternator is not
charging the batteries or if the engine is not running
and the ignition switch is ON.
The normal operating voltage is between 25.5V and
29.5V while the engine is running.
The balance between the two batteries is also
monitored and if a difference of greater than 1.2V
occurs, the battery light is illuminated.
This must be rectified immediately, or damage to
both batteries will occur.
Brake Pressure Warning Light
If the brake system pressure is low, the brake pressure
warning light flashes and the machine must be stopped
immediately.
Machine damage and/or personal injury, perhaps
fatal, may result if this warning is ignored.
The light flashes if the brake systems hydraulic
pressure drops below 123 bar (1 784 psi).
OPERATION