Engine Checks - Bell B35E 6X6 ADT Operator's Manual

The daily or 10 hourly service checks must be
performed by qualified service personnel.
It is recommended that these service checks are
performed in conjunction with the daily walk round
checks so that the operator can assist in the service
checks which require two people.
Report any defects immediately to qualified service
personnel. Damaged pressure hoses should be
replaced by qualified service personnel (hoses
must be replaced, never repaired).
Service Instructions
Ensure that the machine is in the service position.
Use the correct lubricants when topping-up,
replacing and greasing.
NOTE
For further engine information or details not
shown in this manual, refer to the Mer-
cedes-Benz manual's OM470LA, OM471-
LA & OM473LA.

Engine Checks

1. Open the bonnet.
2. Check the bonnet catch for damage and ensure
that the bolts are secure.
NOTE
For further engine information or details not
shown in this manual, refer to the Mer-
cedes-Benz manual's OM470LA, OM471-
LA & OM473LA.
Check Racor Diesel Filler
Check Racor Diesel Filler for water contamination
and Drain at the start of every shift.
10 HOURLY OR DAILY SERVICE AND CHECKS
1. Open the black plastic tap (2) at the bottom of
the Racor filter (1)
2. After all the water has drained from the filter,
tighten the tap
Check Oil Level (Where applicable)
1. Remove the dipstick (1) and wipe clean with a
lint free cloth.
NOTE
When checking the oil level, hold the
dipstick in an upright position with the
point pointing down.
2. Re-insert the dipstick, ensuring that it is prop-
erly seated.
3. Check the oil level.
When the oil is hot, the oil level must be on the
top mark (1) of the dipstick, but not above it.
When the oil is cold, ensure that the level is be-
tween marks (1) and (2), but not below mark
(2).
SERVICE AND CHECKS