Light Switches - Bell B35E 6X6 ADT Operator's Manual

intermittent wiper mode and the windscreen wiper
will wipe once every X seconds; where X can be
configured on the CDU menu.
The left LED will be illuminated when intermittent
wiper mode is active.
If the washer/wiper switch is pressed for less than
0.5 seconds while the intermittent wiper mode is
active then the wiper function will move to low
speed wiper mode and the two left LED's will be
illuminated.
If the washer/wiper switch is pressed for less than
0.5 seconds while the low speed wiper mode is
active then the wiper function will move to high
speed wiper mode and all the LED's will be
illuminated.
If the washer/wiper switch is pressed for less than
0.5 seconds while the high speed wiper mode is
active then the wiper function will be turned off.

Light Switches

Rotating Beacon Light Switch
The Rotating Beacon light switch (top left) is used
to switch the flashing beacon ON or OFF.
The switch has two positions:
• OFF: Normal position.
• ON: Flashing beacon light switched on.
When the rotating beacon light is ON, the LED
above the switch will be on.
Light Switch
The lights switch (top right) is used to switch the
head lights and rear lights on or off.
The park and tail lights will illuminate when the
switch is pressed once and the first LED is
OPERATING COMPONENTS
illuminated, even if the ignition switch is OFF.
However the ignition switch must be ON for the
headlights to operate. The headlight Dip and Bright
functions are controlled from the steering column
switch.
The switch functions as follows:
• OFF: No LED illuminated.
• Pressed once and first LED illuminates; Park and
tail lights ON.
• Pressed twice and both LEDs illuminated: Head-
lights and Park Lights ON.
Working Lights Switch
The working lights switch (bottom right) is used to
operate the working lights on the cab roof shining to
the front of the truck.
The light switch has two positions:
• OFF: No LED illuminated.
• ON: Pressed once: Front and rear working lights
ON and first LED above switch illuminated.
• Second LED is not used.
Mirror Defrost Switch
The mirror defrost switch (bottom left) is used to
defrost the electric mirrors in cold environments.
The switch has two positions:
• OFF: LED not illuminated.
• ON: Mirror defrost is on. LED illuminated.
Do not leave this switch on unnecessarily.
Bin Up/Down Switches
OPERATION