Reverse Warning Buzzer - Bell B35E 6X6 ADT Operator's Manual

OPERATION
OPERATING COMPONENTS
4. Pump the cab upwards until the cab locking
plate is free to rotate from underneath the cab
structure. Ensure that the Cab Locking Plate is
pulled completely forward, clearing the cab tilt
path.
5. While holding the Cab Locking Plate forward,
slowly rotate the cab pump lever to the "lower-
ing position" Cab Down. Release the cab lock-
ing plate once the cab structure has passed the
cab locking plate and continue lowering.
6. Once you have lowered the cab, store the
pump lever in position.
7. Ensure directional valve handle is in "Cab Low-
er" position.
8. Install and torque new locking bolts to 410 N.m.
9. Ensure that the cab mount nut retainers are
centralised after fastening of the cab bolts. This
is important so as to eliminate noise entering
the cab.
Electrical Mirror Brackets (Deluxe Cab
Option)
The electrical mirrors (2) are mounted on a bracket
(1).
The electric mirrors (2) are set with a switch on the
dashboard. There is also a defrost function for the
mirrors operated from a switch on the SSM.
The bracket (1) must be swivelled out to the front or
back of the cab when access to the bonnet area is
required.
Swing the bracket (1) back after work has been
done.
Electrical Air Horn
An electrical horn (1) is installed in the front of the
machine and is activated from the steering column
switch.

Reverse Warning Buzzer

When reverse gear is selected, the reverse lights
illuminate and a warning buzzer (1) sounds at the
rear of the machine.
Rear-view Camera (Option On ADT's)
If the rear-view camera (1) is installed on the
machine, the camera is mounted between the two
reverse lights at the rear of the truck.
The intended use of the camera is to aid the
operator with reversing of the machine, the
operator would be able to spot small object or
persons behind the machine that are not visible in
the rear view mirrors.
The camera is automatically switch on when the
reverse gear is selected, and will display in the
interactive display screen.
There is an option to open the camera view on the
full CDU display screen, using the SDC.