Hazard Switch; Park Brake Switch - Bell B35E 6X6 ADT Operator's Manual

Ignition Off/Engine Stop switch which will turn off
the ignition supply (the LED will stop flashing).
If the Ignition On/Engine Start switch is pressed
while the ignition LED is flashing and the security
code (if relevant) has been entered, the engine will
crank and start automatically.
NOTE
Starting the machine or selecting Drive or
Reverse, will sound the hooter. Twice for
starting and reverse, and once for drive.
This option can be disabled on the CDU.
If the machine does not start then press the Ignition
Off/Engine Stop switch to stop cranking, if you hold
down the Ignition On/Engine Start switch then the
engine will crank ONLY while you have the switch
depressed. The automatic engine crank will turn off
after 15 seconds if the engine has not started.
To stop the engine, press the Ignition Off/Engine
Stop switch. If the switch is pressed while the
engine is turning the machine will go into shut-down
mode. The LED will flash while in shut-down mode.
As the engine speed decreases, the transmission
will go into Neutral and the park brake will be
applied (without the option of releasing it again).
After the park brake is applied the system will go
into a "Turbo Spin-Down" mode and the engine will
be turned off after a certain amount of time (the
time depends upon machine usage, two minutes is
the maximum time taken).
During this shut-down time a countdown timer will
be shown via the CDU and the buzzer will beep
once every second.
IMPORTANT
In case of an emergency press and hold
the Ignition Off/Engine Stop switch, this will
shut down the engine and the ignition
power.
The Turbo Spin Down protects the engine
components by allowing for proper lubrication and
for all temperatures to stabilise before the engine
shuts down.
NOTE
The Ignition On/Engine Start switch will on-
ly operate if the battery isolator switch is
ON.
OPERATING COMPONENTS

Hazard Switch

When the Hazard switch is pressed the indicator
lights, front and rear, will flash, whether the ignition
power is on or off.
The LED above the switch will flash until the switch
is pressed again to switch off the hazard lights.
If the ignition power is off the CDU will not display
the flashing arrows, and the warning beep will not
sound. The LED however will still flash.
The CDU will display the flashing arrows and the
hazard warning beep will also sound if the ignition
is on.

Park Brake Switch

Under normal circumstances the operator must not leave
the machine unattended with the engine running.
If the circumstances are such that the operator must
leave the engine running, the operator must not leave
the machine until he has: Selected and ensured that
the transmission is in Neutral. Applied the park brake
and ensured that it is properly engaged. Chocked the
wheels and taken all other steps necessary to prevent
the machine from moving.
Press the Park Brake Switch to apply park brake.
The LED above the switch will flash until the switch
is pressed again to release the park brake.
The park brake will only release after a gear is
selected or service brake is applied.
The CDU Park Brake Applied Indicator will display
the actual position of the park brake.
OPERATION