Interior Light - Bell B35E 6X6 ADT Operator's Manual

Both pedals are progressive and spring loaded to
an up, disengaged, neutral position.
Auto Greasing Control (Optional)
The automatic greasing system is controlled via the
on-board display and SDC Unit
Do not change the settings, report to service person-
nel if you think a greasing cycle should be changed.
Report to service personnel immediately if the low
level or error light illuminates.
The control enables selection of light, medium or
heavy duty greasing cycles, warns of a low level of
grease in the reservoir and warns of errors in the
system.
Refer to the decal at the side of the control for
further information. The decal is also shown in the
Safety Chapter in this manual.

Interior Light

The interior light in the cab is located in the roof
panel and is switched ON or OFF by pushing the
light at A or B.
OPERATING COMPONENTS
12 V Accessories Socket
The 12 V accessories socket (1) is located on the
left side in the front dash.
Diagnostic Socket
The diagnostic socket is to be used only by trained
personnel.
The operator must ensure that the cover is secure
and undamaged.
A diagnostics socket (2) is installed in the dash for
connecting a diagnostics tool for fault finding.
To gain access to the diagnostic socket, the panel
(1) must be removed.
Fuses, Diodes And Relays
Figure 1 shows the cover on the left of the
dashboard removed to show the fuses, diodes and
relays.
OPERATION