Trainer Seat - Bell B35E 6X6 ADT Operator's Manual

OPERATION
OPERATING COMPONENTS
Armrest
The armrests (11) can be tilted up if required and
the height individually adjusted.
The angular position of the armrests can be
adjusted by turning the adjusting wheel situated
underneath each armrest. The armrests can also
be tilted vertically to allow easier access to the seat.
Seat Belt
Always wear a seat belt when travelling or operating the
machine. In an accident it may save your life.
Check the condition of the seat belt and mounting
hardware before operating the machine.
A self-adjustable 3 - point seat belt is an integral
part of the seat and is designed to fit firmly across
the front of the torso.
Seat belt and mounting hardware must be
inspected before operating the machine. If belt or
mounting hardware is worn, replace complete seat
belt assembly.
It is recommended that the seat belt be replaced at
least every three years, regardless of its condition.
Fastening
Pull the seat belt out and push the buckle (1) into
the fixed clasp (2) until it clicks into position.
Ensure that the connection is secure and that the
belt fits tightly across the pelvis and that the strap of
the belt is not twisted.
Releasing
Press down the red push button (3) on the fixed
clasp. The seat belt is spring-loaded to return to its
retracted stowage position.

Trainer Seat

The trainer seat is located on the left side of the
operator's seat.
The seat is not adjustable and is equipped with a
seat belt.
The seat belt for the trainer is fastened, released
and adjusted in the same way as the operator's
seat belt.
To set-up the trainer seat, lift the front end of the
seat in the upward direction till it is locked in place.
To stow the seat away when not in use:
• While in the open position,
• Place one hand at the front end of the seat and lift
up, while placing your other hand at the rear end
of the seat, pushing in a downward to forward
motion.
• Once the seats begins to swivel in the anti-clock-
wise direction, release the seat.