Check Coolant Level - Bell B35E 6X6 ADT Operator's Manual

SERVICE AND CHECKS
10 HOURLY OR DAILY SERVICE AND CHECKS
4. Re-insert the dipstick, ensuring that it is prop-
erly seated and fasten the dipstick clip.
5. Report and replenish the engine oil if
necessary.
6. Check the level again after replenishing.

Check Coolant Level

Whenever the cap on the expansion tank needs to be re-
moved, remember that the system may be under pres-
sure which could cause hot coolant to be ejected.
Check the coolant level when the engine is cold.
When coolant is drained from the cooling system it
must be replaced with the recommended coolant
specified by the manufacturer.
Report and replenish the coolant if necessary.
NOTE
If there is too much coolant in the tank,
when cold, the tank will purge itself and
overflow with excess coolant.
The coolant must not be lower than the Maximum
Cold mark (1) when the when the engine is cold.
Check Engine Air Intake System
1. Check air cleaner air intake assembly for dama-
ge (1) and air cleaner housing (2).
2. Check rubber elbows, pipes (3) and clamps (4)
for tightness, cracks or damage. Report any
faults to service personnel.
3. Check and ensure that the cover of the power-
core filter is properly secured with all 4 latches
(6), and that there aren't any gaps between the
housing and cover