Sanyo MINI ECO-i XHX1252 Service Manual & Test Run Service Manual page 76

4. System Controller (SHA-KC64UG)
(c) Automatic zone registration using the system controller
(SHA-KC64UG)
(1) Press the and
seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C2 by pressing
and press the button.
C2 changes from flashing to ON state and automatic zone
registration will start.
(3) Any registered GROUP Nos. will be erased.
(4) Central address will be assigned from smallest indoor unit address
to larger ones in numerical order automatically.
On finishing automatic zone registration,
to OFF.
(5) If an error occurs, "CHECK" starts flashing and zone
registration finishes at this time. Press the
(6) Finally, complete automatic zone registration mode by pressing the
button.
flashes for a few minutes, then turns OFF.
buttons at the same time for more than 4
and
changes from flashing
button to start over.
( ) button
2-58
Remote Control Functions