Detailed Setting Function - Sanyo MINI ECO-i XHX1252 Service Manual & Test Run Service Manual

3. Timer Remote Controller (RCS-TM80BG)

16. Detailed Setting Function

All settings except for the system address, indoor unit
address, and group address were set at the time of
shipment. The following procedures are necessary
only when the functions are changed.
The functions cannot be changed in the case of a
wireless remote controller or a system with no remote
controller.
Change the functions using the wired remote con-
troller (RCS-TM80BG).
<Function>
Sets items which are highly important for system
operation, such as the system address, indoor unit
address, and group address, at the individual or
group-control indoor unit(s) where the remote con-
troller that is used for making detailed settings is con-
nected.
CAUTION
These settings are for items that are extremely
important for system operation. Serious trouble
may occur if they are set incorrectly. Please use
sufficient caution when changing the settings.
Some item codes which do not appear in the list
are also displayed. These item codes were set at
the time of shipment from the factory to the opti-
mal settings for that model; do not change them.
Do not change any settings data which does not
appear in this list.
<Procedure>
(Perform these steps with the unit stopped.)
1 Press and hold the
(SET) button and
simultaneously for 4 seconds or longer. Check
that the (SETTING) display on the remote
controller begins to blink.
2 If group control is in effect, press the
(UNIT SELECT) button and select the address
(unit No.) of the indoor unit to set. At this time, the
indoor unit fan begins operating.
3 Press the temperature setting
buttons to select the item code to change.
(TEST/CHK) button, the
(CANCEL) button
/
7
1
Press the timer time
4
the desired setting data.
* For item codes and setting data, refer to the fol-
lowing page.
5 Press the (SET) button. The
display stops blinking and remains lit, and setting is
completed. (If the
the settings data will not be changed.)
6 Repeat steps (2) – (5) and change the settings.
<Restoring normal mode>
7 Press the (TEST/CHK) button. Check that the
remote controller display disappears.
2-35
Remote Control Functions
5 4
/ buttons to select
(SETTING)
(SET) button is not pressed,
2
3
2