Sanyo MINI ECO-i XHX1252 Service Manual & Test Run Service Manual page 25

2. Wireless Remote Controller
NOTE This function is available only for models X, A, T and K.
J: TIMER SET button
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
K: Time setting buttons
L: SET button
M: CL button
N: VENTILATION button
O: Remote control sensor
p: ACL button (ALL CLEAR)
Q: Slide switch
Indicator when swing operation is stopped
Fan and heating
During cooling and drying, the flap does not stop at the downward position.
Even if the flap is stopped at the downward position during the swing operation, it does not
stop until it moves to the third position from the top.
Use this button while the unit is operating to switch between timer settings.
: The air conditioner stops after a preset time elapses.
: The air conditioner always stops after a preset time elapses.
: The air conditioner starts after a preset time elapses.
: Press this button to increase the time.
: Press this button to decrease the time.
Use this button to set the timer.
Use this button to clear the timer setting.
This is used when a ventilation fan (available commercially) is connected. Pressing the
VENTILATION button turns the fan on and off. The ventilation fan also turns on and off when
the air conditioner unit is turned on and off. (The display of the remote control unit shows
" " while the ventilation fan is running.)
* If the VENTILATION button is held down for 4 or more seconds when the batteries have
been replaced, " " appears on the display, and the ventilation fan can be used.
This detects the temperature around the remote control unit when the remote control unit
position has been selected using the sensor button.
Puts the wireless remote control unit into pre-operation status. This is used after the batter-
ies have been replaced or when the slide switch setting has been changed.
This switch is for setting the operation mode of the indoor unit and setting the flaps.
The wireless remote control unit sends the temperature signal to the air
NOTE
conditioner regularly at five-minute intervals. If the signal from the wireless
remote control unit stops for more than ten minutes due to the loss of the
wireless remote control unit or other trouble, the air conditioner will switch to
the temperature sensor which is built into the indoor unit and control the room
temperature. In these cases, the temperature around the wireless remote
control unit may differ from the temperature detected at the air conditioner's
position.
When low fan speed is selected and the air conditioner is in cooling opera-
tion at a low outdoor temperature of less than 50°F (10°C), the air conditioner
may automatically switch to medium fan speed to prevent freezing.
2-7
Cooling and drying
Remote Control Functions
2