Sanyo MINI ECO-i XHX1252 Service Manual & Test Run Service Manual page 77

4. System Controller (SHA-KC64UG)
How to check for overlapping of central address Nos.
(1) Press the and
seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C3 by pressing
press the button.
C3 changes from flashing to ON state and
auto overlap checking will start.
(3) If C3 changes from ON to flashing and
disappears, there is no overlapping.
Then finally, complete the auto overlap checking mode by pressing
the button.
(4) If some of GROUP No., ZONE No. and UNIT No. flash, you should
try the zone registration again.
Select CODE No. C1 by pressing
1
press the button.
Select the flashing GROUP No. with ZONE and GROUP button.
2
Then press the
UNIT No.
Then finally, complete the auto overlap checking mode by
3
pressing the button.
buttons at the same time for more than 4
,
stops flashing and
,
button and reselect the ZONE, GROUP and
( ) button and
will flash. Then
( ) button and
2-59
Remote Control Functions
2