Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 26

9 IN120 /IN220 Installation Instructions (Continued)
2 Installation of Connectors (Continued)
Important Note: If you are installing IN220 (PoE)*:
E. Strip Ethernet cable jacket (3) inches.
F. Separate (untwist) and straighten (8) Ethernet wires before carefully
feeding through ferrite bead (Fig.16d).
G. Crimp RJ45 (male) connector on end of wires.
*For more detail, refer to section (7) 'Installation Wiring',
"A - Frame Harness Installation".
3 Installing the Controller
Apply dielectric grease to connector* located on back of Controller (FIG. 17b, c).
CAUTION - Do not allow debris to enter connector contacts.
Fig. 17a
Important Note: Before you install the controller
RJ45-M
*Be sure to apply grease to connector and recessed area
Fig. 17b
26
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written permission
of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
ED5200N / ED5600N Series
Exit Devices for 9100/9M100
Fig. 16d
Feed wires thru ferrite
bead (PoE only)
Crimp wires to
RJ45-M Connector
(PoE only)
surrounding connector
Fig. 17c