Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 8

6 IN220 (PoE) Wiring and Installation Instructions (Continued)
Supplied by CI
B-Splice
Crimp Connector
RJ45-M
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain wire
concealed in
shrink tubing
Molex-F
Molex-M
A
Certified Integrator (CI) supplies and terminates
the B-Splice connector and the
Male RJ45 connector from harness to
end user provided facility cable
To building or electrical ground
Cable: Cat5e or higher
RJ45-F Jack
24 AWG
NOTE: TIA/EIA 568-B added
only at lock side
Cable
: Cat5e or higher,
B
26 AWG stranded,
shielded, 100ohm
C
Molex-F Molex-M
Ring Terminal
Secured to Lock
Mounting Plate
TIA/EIA 568-B Standard Wiring
Patch Cable:
PoE Panel to
PoE Switch
D
PoE
Lock
RJ45-M
Ground
8
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written permission
of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
ED5200N / ED5600N Series
Exit Devices for 9100/9M100
Supplied by End User
PoE Switch
PoE Switch
Rack is
Terminated to
Earth Ground
PoE Patch Panel
Approved Software
Notes:
• Connectors go on only one
way. They cannot be placed
in an incorrect position.
• Do not force and do not
offset connectors
• Be sure they are completely
seated (flush)
• PoE power source cannot be
connected to a receptacle
controlled by a switch