Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 18

8 Mortise Exit Installation Instructions (Continued)
3 Install Door Position Switch (DPS)
a. Insert DPS into the raceway on the latch edge of the door.
b. Push wires through raceway toward lock prep.
c. Push DPS firmly into place by hand.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
d. Install magnet into door frame. Push firmly into place by hand.
See instruction A7983.
CAUTION: if DPS is not installed or is installed
improperly, door status monitoring features will
not function.
IN220 PoE
Harness
(cat5e or
higher)
Fig. 10
18
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written permission
of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
ED5200N / ED5600N Series
Exit Devices for 9100/9M100