Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 19

IN120 & IN220 Series
ED5200N / ED5600N Series
Exit Devices for 9100/9M100
8 Mortise Exit Installation Instructions (Continued)
4 Install Mortise and Outside Trim Assembly
a. Insert lock body (Fig. 11a) .
b. Feed trim wire harness through wire harness hole.
c. Mount trim assembly to door pulling slack wire towards device side of door.
Note: Be careful not to pinch wire harness.
Note: Ensure tailpiece is still oriented vertically.
d. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 11b).
Note: Finger tighten only.
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN220 PoE
Harness
(cat5e or
higher)
Fig. 11a
19
IN220 PoE
Fig. 11b
Harness
(cat5e or
higher)